Building under special conditions such as non-magnetic building.
We are contracted by U.S. subsidiary of JAE Electronics to design and construct offices located near Houston, Texas, as well as a product repair center. We handled this project from the ground up, starting with a vacant lot in a remote location. With our design builder acting as on-site project manager.
The calibration building needed to be a non-magnetic building, meaning that there could be no metal used throughout the entire building, to not interfere with electronic measuring instruments.
To address these restrictions, we explored many possible challenges at the design stage, including the location of the building and materials used. At the construction stage we also carried out strict quality control, conducting meticulous tests and inspections. To prevent metal contamination, including metal fragment contamination while pouring concrete, and ensure that all nails used were a specific, non-magnetic type of stainless steel.